Store Home   Forum Home   Help & Contact Info   Bank & Payment Details   DIY Go Kart Plans


NORAM Cheetah Clutch Engagement Adjustment

Moderator: Specialists

NORAM Cheetah Clutch Engagement Adjustment

Postby cutpriceracing » Sun May 11, 2014 7:05 am

Attachments
CLCH01_4.jpg
CLCH01_4.jpg (20.1 KiB) Viewed 17006 times
CLCH01_3.jpg
CLCH01_3.jpg (31.51 KiB) Viewed 17006 times
CLCH01_2.jpg
CLCH01_2.jpg (23.68 KiB) Viewed 17006 times
CLCH01-(5).jpg
CLCH01-(5).jpg (20.38 KiB) Viewed 17006 times
cheetah-engagement-settings.pdf
(286.4 KiB) Downloaded 2041 times
cutpriceracing
Site Admin
 
Posts: 132
Joined: Fri Sep 14, 2012 6:50 am

Re: NORAM Cheetah Clutch Engagement Adjustment

Postby cutpriceracing » Thu Jan 29, 2015 9:15 pm

Returning Springs to Stock Setting
1. Remove flat head screw, silver spacer and spring.
2. Install new spring, washer and screw.
3. Tighten screw so until the top of the screw is .41 inches in height as measured with a caliper.
*NOTE* This is approximately 5 full turns back out from fully tightened position.
4. Install on kart and check engagement.
5. To raise engagement turn all screws the same amount clockwise.
to lower engagement turn all screws the same amount counterclockwise
Reste.jpg
Reste.jpg (12.43 KiB) Viewed 16732 times
cutpriceracing
Site Admin
 
Posts: 132
Joined: Fri Sep 14, 2012 6:50 am


Return to Gearing

Who is online

Users browsing this forum: No registered users and 2 guests