Page 1 of 1

NORAM Cheetah Clutch Engagement Adjustment

PostPosted: Sun May 11, 2014 7:05 am
by cutpriceracing

Re: NORAM Cheetah Clutch Engagement Adjustment

PostPosted: Thu Jan 29, 2015 9:15 pm
by cutpriceracing
Returning Springs to Stock Setting
1. Remove flat head screw, silver spacer and spring.
2. Install new spring, washer and screw.
3. Tighten screw so until the top of the screw is .41 inches in height as measured with a caliper.
*NOTE* This is approximately 5 full turns back out from fully tightened position.
4. Install on kart and check engagement.
5. To raise engagement turn all screws the same amount clockwise.
to lower engagement turn all screws the same amount counterclockwise
Reste.jpg
Reste.jpg (12.43 KiB) Viewed 16746 times